Good day, now I am on a 2014 BMW 640d, and I wanna use Autel MaxiIM IM608 tool to program a key via OBD.
Here is a 868 megahertz BMW key, and a new smart key to be programmed.
Connect Autel IM608 with the OBD port of BMW, let’s go to start:
IMMO >> Accept >> BMW >> Smart selection >> OK
Key learning >> OK >> OBD learning >> OK
OBD Read SK >> OK >> Yes
Hold the working BMW key closely on the side of start coil, then press “OK”.
Read password successful, press “OK”.
Select a free slot Key5, then press “Write key”.
Put the new key close to start coil, key frequency: 868 MHz, press “OK”.
Processing…
The ignition was just switched off and switched back on again.
Write key successful! Follow the instructions and press “OK”.
Put the key close to start induction coil, press and hold the ignition for 10s. After the learning is completed, the key can be normally used.
Now let me see if this new key works… there you go, starts up absolutely fine.
BMW Key programming has been done.
This is a short demonstration of using Autel IM608 Key Programmer to add a new key for 2014 BMW CAS4 via OBD. It is quite easy and fast to finish in 3 minutes.