How to Calibrate Autel EVO II Drone Remote Controller?

 

It is recommended to calibrate the remote controller of Autel EVO II Drone when the following situations happened:

  1. The remote controller is dropped on the ground.
  2. The aircraft’s flight direction does not match control inputs.
  3. The remote controller automatically enters the calibration procedure when it is turned on.

 

Remote Controller Calibration

 

Step1. Turn off the EVO II aircraft and the remote controller.

Calibrate Autel Evo Ii Drone Remote Controller (1)

 

Step2. Press and hold the Power Button and Take-off Button of remote controller simultaneously for 3 seconds.

Calibrate Autel Evo Ii Drone Remote Controller (2)

 

Step3. You can start the calibration when the remote controller screen lights up and enters the calibration screen.

 

Push and hold the Command Sticks, in each of the eight possible directions until you hear a beep each time.

Calibrate Autel Evo Ii Drone Remote Controller (3)

 

Step4. Turn the left Gimbal Pitch Dial counterclockwise until you hear a beep, and then clockwise until you hear a beep.

 

Calibration successful!

Calibrate Autel Evo Ii Drone Remote Controller (4) Calibrate Autel Evo Ii Drone Remote Controller (5)

 

The calibration program will close automatically.

 

Done!

 

This is a remote controller calibration tutorial applies to Autel Robotics EVO II 8K and Autel Robotics EVO II Pro 6K aircraft.

https://www.auteldiag.com/